Repsol Posted June 12, 2010 Share Posted June 12, 2010 I loved this picture lol. Little small though. Cell pic FTL. Link to comment Share on other sites More sharing options...
Ben. Posted June 13, 2010 Share Posted June 13, 2010 Yay for no hood clearance. D: Link to comment Share on other sites More sharing options...
Repsol Posted June 13, 2010 Author Share Posted June 13, 2010 Lol the only thing that hits is the feed line. :( Link to comment Share on other sites More sharing options...
Ben. Posted June 13, 2010 Share Posted June 13, 2010 Yea..that crucial thing. LOL. Sucks that you can't cleanly pull off any kinda cowl hood.. However you can probably raise the hood at the hinges a little bit and give it a little more clearance, don't know that it'd clear even then though. Link to comment Share on other sites More sharing options...
SpeedDemon Posted June 13, 2010 Share Posted June 13, 2010 just cut a hole in the hood and weld a concave piece over it. like an umberella (jk jk, umbrella) Link to comment Share on other sites More sharing options...
Repsol Posted June 13, 2010 Author Share Posted June 13, 2010 Well it actually clears just fine with some hood spacers. They're about an inch high. It's just my motor mounts are soooo bad, it rocks so much causing it to hit the hood. Link to comment Share on other sites More sharing options...
Ben. Posted June 13, 2010 Share Posted June 13, 2010 Good stuff. Link to comment Share on other sites More sharing options...
mpearce1974 Posted June 13, 2010 Share Posted June 13, 2010 This like a episode of Pimp My Ride hosted by Red Green! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.