95-del-sol Posted February 9, 2013 Share Posted February 9, 2013 I tried taking a nut off the intake/cylinder head stud but it doesn't move. I could turn it 50 times and it wont tighten or loosen. Any ideas on how I'd remove it? Link to comment Share on other sites More sharing options...
TANK86 Posted February 9, 2013 Share Posted February 9, 2013 i had something like that b4. only thing that got it off was try and get a flat head in between both, and turn as in loosening, and keep pressure. if not working, heat up the bold and do the same. sucks but works. may need to look into re threading after, 50/50 Link to comment Share on other sites More sharing options...
95-del-sol Posted February 9, 2013 Author Share Posted February 9, 2013 Yeah I was thinking about doing that wedging a prybar/flat head - but then I had to leave for class. Link to comment Share on other sites More sharing options...
TANK86 Posted February 9, 2013 Share Posted February 9, 2013 what are your reasons for taking it off in the first place? Link to comment Share on other sites More sharing options...
95-del-sol Posted February 9, 2013 Author Share Posted February 9, 2013 Head gasket blew. Link to comment Share on other sites More sharing options...
TANK86 Posted February 9, 2013 Share Posted February 9, 2013 damn. are you still driving it? i never had to take off the bolts that held the intake manifold on. i have to do one tomorrow for a d16y8 Link to comment Share on other sites More sharing options...
95-del-sol Posted February 9, 2013 Author Share Posted February 9, 2013 No its parked. I wanted to clean the intake. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.