Ketnity151 Posted July 8, 2009 Author Share Posted July 8, 2009 ok.. heads ready at the machine shop, picking it up in the morning.. yay! <-- giddy school-girl moment again.... anyway.. i got pistons out and cleaned up and the old rings off.. now, before i put the new rings on for good, i gotta measure the ring end gap, but do i do that before or after i glaze break the cylinders? and when i get all that done, it says to oil the rings and cylinders before installation, so do i just dip the rings in oil before i put em on, or do i put them on and then rub oil onto the sides of the pistons on the rings? Link to comment Share on other sites More sharing options...
xxhrdcr4lifexx Posted July 9, 2009 Share Posted July 9, 2009 i do beleive you dip the rings then put them on and put a coat of oil on the cyl walls Link to comment Share on other sites More sharing options...
Ketnity151 Posted July 9, 2009 Author Share Posted July 9, 2009 ok, so what about my first question? measure ring end gap before or after glaze break honing the cylinders? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.